-
- Out of Stock
- Other Modules
CH376S U Disk Read Write Module For USB Control Transfer
- 110.00 EGP
- CH376 is common a USB bus interface chip, with 8 bit data bus and reading, writing and chip select lines and interrupt output, can easily attached to the system bus of the single chip microcomputer /DSP/MCU/MPU controller.
- Read more
-
-
- Sale!
- Other Modules
Relay Module (5V-10A) 1Channel Low level trigger
- Original price was: 35.00 EGP.30.00 EGPCurrent price is: 30.00 EGP.
- This 5V 10A Relay Module is a simple yet powerful solution for controlling high-voltage devices with low-voltage microcontroller signals. Featuring a single channel relay with low-level trigger input, it allows you to switch loads up to 10A safely and efficiently.
- Add to cart
-
- Other Modules
High-power MOSFET Trigger Switch Drive Module
- 40.00 EGP
- High-power MOSFET Trigger Switch Drive Module
- Add to cart
-
- Modules, Other Modules
Mini 5V Traffic Light LED Display Module for Arduino Red Yellow Green 5mm LED
- 30.00 EGP
- Mini 5V Traffic Light LED Display Module with Red, Yellow, and Green 5mm LEDs. Perfect for Arduino, Raspberry Pi, and DIY projects to simulate real traffic signals. Ideal for education, robotics, and STEM learning.
- Add to cart
-
- Other Modules
I2C Arduino Serial Module For LCD 16*2
- 40.00 EGP
- Simplify your LCD connections with this I2C serial interface module, designed specifically for standard 16x2 character LCD displays. This compact adapter converts the LCD's parallel interface into a simple I2C (I²C) 4-wire connection, drastically reducing wiring complexity and saving precious GPIO pins on your microcontroller.
- Add to cart
-
- Other Modules
Joystick Module X-Y For Arduino
- 28.00 EGP
- Lots of robotic projects need a joystick. This module offers an affordable solution to that. The Joystick module is similar to analog joysticks found in gamepads. It is made by mounting two potentiometers at a 90 degrees angle. The potentiometers are connected to a short stick centered by springs.
- Add to cart
-
- Out of Stock
- Other Modules
Micro-USB Female Breakout Module
- 15.00 EGP
- A Female MicroUSB port with breakout board so you can solder on wires or header pins and integrate into any project.
- Read more
-
-
- Sale!
- Other Modules
GY-521 MPU6050 Triple 3-Axis Accelerometer Gyroscope I2C
- Original price was: 150.00 EGP.125.00 EGPCurrent price is: 125.00 EGP.
- The GY-521 module is a compact and powerful sensor board based on the MPU6050 chip, which combines a 3-axis accelerometer and a 3-axis gyroscope in a single package. This module is ideal for motion tracking, gesture detection, and stabilization in a wide range of applications including robotics, drones, gaming, and wearable tech.
- Add to cart
-
- Out of Stock
- Other Modules
MAX6675 Module for Thermocouple K Type
- 225.00 EGP
- This K Type Thermocouple can be used to measure temperatures up to 600 degree Celsius! Great for industrial projects, 3D Printers, DIY and hobby projects which require a high temperature to be measured.
- Read more
-
-
- Other Modules
4 Output Relay Module Works on 5V Signal
- 150.00 EGP
- This 4-Channel 5V Relay Module allows you to control high-voltage AC/DC devices (up to 250V AC / 30V DC @ 10A per channel) using a low-voltage 5V signal from microcontrollers like Arduino, ESP8266, Raspberry Pi, or PLCs. Each relay is optically isolated (optocoupler-protected), preventing back EMF damage to your control circuit. Perfect for home automation, industrial control, and IoT projects, this module supports both HIGH and LOW-level triggering (configurable via…
- Add to cart
-
- Batteries & Accessories, Chargers, Modules, Other Modules
Lithium Battery Charger Protection Module (BMS) 3S 40A 12.6V
- 85.00 EGP
- A compact and versatile storage solution designed for organizing small electronic components, screws, beads, and craft supplies. This 10-compartment plastic box features transparent lids for easy identification and secure snap-lock closures to prevent spills.
- Add to cart
-
- Components, Other Modules, Relays
Relay Module 2 Channel 12V (high/low) level trigger
- 75.00 EGP
- This 2-Channel 12V Relay Module allows you to control high-voltage/high-current devices (up to 250V AC / 30V DC @ 10A per channel) using a 12V control signal, making it ideal for automotive, industrial, and home automation applications. Each relay features optocoupler isolation for protection against voltage spikes and supports both HIGH and LOW-level triggering (configurable via jumper).
- Add to cart
-
- Out of Stock
- Other Modules
12V Delay Timer Switch Adjustable
- 45.00 EGP
- This 12V Delay Timer Switch Adjustable 0-10sec is one kind of popular switch module. You can use it control any devices on or off. This is a DC12V controlled 1 channel timer relay module. It has a NE555 timer chip on the board. You can adjust delay time(0-10s) by rotating the potentiometer. When this relay get powered it will delay…
- Read more
-
-
- Out of Stock
- Other Modules
Micro SD Card Module
- 50.00 EGP
- Micro SD card mini TF card reader module SPI interfaces with level converter chip
- Read more
-
-
- Out of Stock
- Other Modules
1.2v 12v ZB2L3 18650 Li-ion Lithium Battery Capacity Tester + Resistance Lead-acid Battery Capacity Meter Discharge Tester
- 140.00 EGP
- This circuit in order to improve the voltage measurement accuracy, specially designed DC bias, when the terminal is what all don't pick will display a small voltage, does not affect the actual measurement, if you are short connected with the input terminal (absolute 0V) will display 0. To understand the principle can consult the superposition theorem in electrical engineering.
- Read more
-
-
- Other Modules
NE555 Adjustable Frequency Pulse Generator Module
- 30.00 EGP
- This NE555-based pulse generator module is a versatile and easy-to-use signal source capable of producing adjustable-frequency square waves for timing, PWM, tone generation, and motor control. With onboard potentiometers for fine-tuning, it’s perfect for prototyping, testing, and educational projects.
- Add to cart
-
- Out of Stock
- Other Modules
Relay Module 2 Channel 5V (high/low) level trigger
- 80.00 EGP
- This versatile 2-Channel 5V Relay Module allows you to control two independent high-voltage devices using low-voltage signals from microcontrollers like Arduino, Raspberry Pi, ESP32, and more. It supports both high-level and low-level trigger modes, making it compatible with a wide range of control circuits.
- Read more
-
-
- Other Modules
Single Channel 5V DC Relay Module Solid State Low Level Trigger
- 70.00 EGP
- This Single-Channel 5V DC Solid State Relay (SSR) Module provides silent, fast-switching control for AC/DC loads using a low-level (0V) trigger signal from microcontrollers like Arduino, ESP8266, or Raspberry Pi. Unlike mechanical relays, this SSR has no moving parts, ensuring longer lifespan, zero noise, and no contact sparking. Perfect for high-speed switching applications, such as temperature controllers, LED lighting, and small appliances, this module supports DC control (5V) and AC/DC load…
- Add to cart
-
- Medical Sensors, Modules, Other Modules, Sensors
KY039 Finger Detection Heartbeat Measuring Sensor Module
- 30.00 EGP
- The KY-039 Heartbeat Sensor Module is a photoplethysmography (PPG)-based sensor designed to detect heartbeat/pulse signals by measuring blood flow changes in fingertips or earlobes. This low-cost module uses an infrared (IR) LED and phototransistor to capture pulse waveforms, making it ideal for health monitoring, fitness tracking, and biomedical projects. With simple analog output compatibility, the KY-039 can interface with Arduino, Raspberry Pi, and other microcontrollers to visualize real-time pulse data or trigger alerts.
- Add to cart
-
- Out of Stock
- Other Modules
12V Battery Level LED Indicator
- 45.00 EGP
- XD-82B 12V Battery Level Indicator Module 4 Paragraph 4 onboard Battery Indicator LED Lights. Monitor the level of your 12v battery and know when it’s running low with this small LED battery level indicator.
- Read more
-
-
- Modules, Other Modules
LASER Receiver Module
- 65.00 EGP
- This Laser Receiver Module is a high-sensitivity photoelectric sensor designed to detect laser beams (650nm red or 850nm IR) for precision alignment, security systems, and industrial automation. With a digital/analog output, it’s perfect for Arduino, PLCs, and DIY projects requiring beam-break detection.
- Add to cart
-
- Batteries & Accessories, Modules, Other Modules
LCD Dual USB 5V 1A 2.1A Mobile Power Bank Module
- 150.00 EGP
- The LCD Dual USB Power Bank Module is a smart charging control board designed for DIY power banks, portable chargers, and backup battery projects. Featuring dual USB outputs (5V/1A + 5V/2.1A), an LCD battery level display, and overcharge/discharge protection, this module efficiently converts 3.7V Li-ion/Polymer batteries into a reliable power source for smartphones, tablets, and USB devices. With real-time voltage/current monitoring and compact design, it’s perfect for hobbyists and professionals building custom power solutions.
- Add to cart
