Skip to content
-
-
-
Out of Stock
- Motor Drivers
-
242.00 EGP
- 10A Single Channel DC Motor Drive Board Module Industrial Large Power MOSFET Single H Bridge w/ Braking
- Read more
-
-
Out of Stock
- Motor Drivers
-
132.00 EGP
- It’s an I2C-controlled PWM driver with a built in clock. Adjustable frequency up to about 1.6 KHz. 12-bit resolution for each output for servos, that means about 4us resolution at 60Hz update rate.
- Read more
-
-
-
Out of Stock
- Motor Drivers
-
308.00 EGP
- 30A RC Brushless Motor Electric Speed Controller ESC Yellow for Airplane Quadcopter Drone Model Helicopter Parts
- Read more
-
-
-
Out of Stock
- Motor Drivers
-
990.00 EGP
- 3M660 is a constant torque microstepping driver, voltage range from 24-58VDC, it’s suitable for various 3-phase NEMA23 & NEMA34 hybrid stepper motorWith the build-in constant current chopping circuit similar to servo driver, the motor run stable without vibration and noise in low speed.
- Read more
-
-
Out of Stock
- Motor Drivers
-
242.00 EGP
- 4 Channels Dc Servo Stepper Motor Driver Module For Arduino L298
- Read more
-
-
-
- Motor Drivers
-
95.00 EGP
- The EasyDriver is a simple to use stepper motor driver, compatible with anything that can output a digital 0 to 5V pulse (or 0 to 3.3V pulse if you solder SJ2 closed on the EasyDriver).
- Add to cart
-
-
-
-
Out of Stock
- Motor Drivers
-
242.00 EGP
- Arduino Shield “Monster Moto – Motor Driver 30A One Channelâ€
- Read more
-
-
-
Out of Stock
- Motor Drivers
-
420.00 EGP
- This drive is an upgraded version of TB6600, heightening segments to 32 segments, for high-use segments. Applicable stepper motor: 42,57,86 type 2-phase 4-phase (4-wire line 6 line 8)
- Read more
-
-
-
-
- Motor Drivers
-
120.00 EGP
- The DRV8825 stepper motor driver carrier is a breakout board for DRV8825 microstepping bipolar stepper motor driver. The module has a pinout and interface that are nearly identical to those of our A4988 stepper motor driver board, so it can be used as a higher-performance drop-in replacement for those boards in many applications. The DRV8825 features adjustable current limiting, overcurrent…
- Add to cart
-
-
Out of Stock
- Motor Drivers
-
264.00 EGP
- The Dual Monster Moto Shield VNH2SP30 DC Motor Driver 2x14A (Peak 30A) is essentially a ramped up version of our Ardumoto motor driver shield. For this Monster Moto Shield, It is replaced the L298 H-bridge with a pair of VNH2SP30 full-bridge motor drivers.
- Read more
-
-
Out of Stock
- Motor Drivers
-
275.00 EGP
- IBT-2 43A H-Bridge Motor Driver Module the drive uses an H-bridge driver module that composed by Infineon power drive chip BTS7960, with overheating and overcurrent protection. motor driver H-bridge driver circuit, with strong drive and braking effect, use 74HC244 chip effectively isolate the microcontroller and the motor drive High Current up to 43A IBT-2 motor driver is a fully integrated…
- Read more
-
-
Out of Stock
- Motor Drivers
-
165.00 EGP
- DC Motor Driver The drive module can directly drive four DC motors, drive the car chassis is 4WD 4 choice. Driving battery big up to 1A generally smart car motor current 100-300MA only four are sufficient to meet the control requirements. The circuit stability. Can directly drive 4-way 3-16V DC motor, and provides a 5V output interface (input as little…
- Read more
-
-
-
-
- Motor Drivers
-
165.00 EGP
- Large Current Dual Dc Motor Driver using ST STMicroelectronics outstanding high-power motor driver chip dedicated L298N, direct drive DC motors, two-phase, four-phase stepper motor drive current up to 2A, motor output using eight-speed Schott group as a protective diode. The circuit line wiring reasonable mount components are used in films, laminated design can be directly plugged into the use of…
- Add to cart
Notifications
