Search Results for "module"
-
STM32F401CCU6 Development Board For Arduino
STM32F401 Minimum System Development Board Module STM32F401CCU6
198.00 EGPSTM32F401CCU6 Development Board For Arduino
198.00 EGP -
-
OLED 0.96 inch 128×64 white Display Module ( Unsoldered )
Yellow Blue OLED Display Module 0.96 Inch IIC Serial 128X64 I2C SSD1306 12864 LCD Screen Board GND VCC SCL SDA for Arduino STM32
140.00 EGP -
Control Board Ramps 1.6 for 3D Printer
Control Board Ramps Ramps 1.6 Expansion Control Board with Heatsink Upgraded Ramps 1.4 1.5 for Arduino 3D Printer Board
220.00 EGPControl Board Ramps 1.6 for 3D Printer
220.00 EGP -
Led Matrix 8×8 With MAX7219 Module
The MAX7219 Dot Led Matrix Module is a serial input common-cathode driver that interfaces micro-controllers to LED matrices
50.00 EGPLed Matrix 8×8 With MAX7219 Module
50.00 EGP -
Arduino Nano Shield
This shield is designed for Arduino Nano, you can make Arduino Nano’s pins layout same as standard shield’s easily.
55.00 EGPArduino Nano Shield
55.00 EGP -
1.3″ OLED 7 Pins Display – White 128X64
OLED 128×64 dot matrix display module. The characteristics of this display module are high brightness, self-emission, high contrast ratio, slim/thin outline, wide viewing angle, wide temperature range and low power consumption.
165.00 EGP1.3″ OLED 7 Pins Display – White 128X64
165.00 EGP -
HW-069 4 Digits 7 Segment Display Module with 0.36Inch Time Clock TM1637 Driver
The module is a 12-pin display module with a 4-point common digital tube (0.36 inch) with a clock point.The driver chip is TM1637.
It only needs 2 signal lines to enable the MCU to control the 4-bit 8-segment digital tube
45.00 EGP -
CNC Router Single Axis 4.5A TB6600 Stepper Motor Driver
CNC Router Single Axis
600.00 EGP -
3D Print Control Board Ramps v1.4 Shield for Arduino Mega
Ramps is short for reprap Arduino Mega shield, it is mainly designed for the purpose of using stepper driver board (similar to 4988 driver board). Ramps can only work when connected to mainboard Mega 2560 and DRV8825. Great compatibility with most 3Dprinter (all reprap-model such as pursa i2 and i3).
Note: This Board is only the shield, Stepper Drivers and mainboard are not included.
170.00 EGP -
5 inch HDMI Touch Screen TFT LCD Panel Module Shield 800X480 For Raspberry Pi
5 inch HDMI Touch Screen TFT LCD Panel Module Shield 800X480 For Raspberry Pi.
1,500.00 EGP