-
- Out of Stock
- Other Modules
CH376S U Disk Read Write Module For USB Control Transfer
- 110.00 EGP
- CH376 is common a USB bus interface chip, with 8 bit data bus and reading, writing and chip select lines and interrupt output, can easily attached to the system bus of the single chip microcomputer /DSP/MCU/MPU controller.
- Read more
-
-
- Out of Stock
- Converters
DC-DC Adjustable Step-Down Power Supply Module -XL4005 5A 75W DSN5000
- 48.00 EGP
- XL4005 is a 300KHz fixed frequency PWM buck (step-down) DC/DC converter, capable of driving a 5A load with high efficiency, low ripple and excellent line and load regulation. Requiring a minimum number of external components, the regulator is simple to use and include internal frequency compensation and a fixed-frequency oscillator.
- Read more
-
-
- Sale!
- Bluetooth
Bluetooth Module HC-05 Pinout, AT Commands & Arduino Programming
- Original price was: 235.00 EGP.200.00 EGPCurrent price is: 200.00 EGP.
- Very simple Bluetooth module to connect it with your microcontroller, Arduino, Raspberry Pi, or any MCU board using the TTL UART interface This serial bluetooth module can work as either master or slave. This module also includes the base board, not only the core board, most functions are pre-set, so only the serial port communication is available but it’s more easy to…
- Add to cart
-
- Converters, Modules
HW-183 Board DC-DC Step Up Power Module 2A B6287
- 55.00 EGP
- The HW-183 DC-DC Step-Up Power Module is a high-efficiency boost converter based on the B6287 IC, designed to increase low DC voltage to a higher, stable output (up to 28V at 2A). Ideal for powering LED strips, motors, portable devices, and DIY electronics, this compact module efficiently converts 2V–24V input into adjustable output voltage with up to 96% efficiency. With its built-in potentiometer for voltage adjustment, overcurrent protection, and minimal heat generation, the…
- Add to cart
-
- Sale!
- Other Modules
Relay Module (5V-10A) 1Channel Low level trigger
- Original price was: 35.00 EGP.30.00 EGPCurrent price is: 30.00 EGP.
- This 5V 10A Relay Module is a simple yet powerful solution for controlling high-voltage devices with low-voltage microcontroller signals. Featuring a single channel relay with low-level trigger input, it allows you to switch loads up to 10A safely and efficiently.
- Add to cart
-
- Converters
PL2303 USB TTL Converter Module
- 55.00 EGP
- The PL2303 USB to TTL Converter Module is a high-performance USB-to-serial adapter designed for debugging, programming, and communication between computers and microcontrollers or embedded systems. It is widely used for Arduino, Raspberry Pi, ESP8266, STM32, and other microcontroller projects.
- Add to cart
-
- Other Modules
High-power MOSFET Trigger Switch Drive Module
- 40.00 EGP
- High-power MOSFET Trigger Switch Drive Module
- Add to cart
-
- Out of Stock
- Converters
USB to TTL converter UART module CH340
- 65.00 EGP
- USB to TTL converter UART module CH340G CH340 3.3V 5V switch
- Read more
-
-
- Out of Stock
- Wireless
ESP8266 WiFi 4 channel Relay Module
- 450.00 EGP
- DC 12V ESP8266 4 channel relay board ESP-01 WIFI module 4 channel WIFI relay module for smart home smart furniture
- Read more
-
-
- Converters
CP2102 USB 2.0 to TTL UART Serial Converter Module With DTR Pin
- 120.00 EGP
- The CP2102 USB to TTL Serial Converter Module is a compact and powerful interface designed for seamless USB-to-serial communication. Featuring the Silicon Labs CP2102 chipset, this module is ideal for flashing, debugging, and communicating with microcontrollers and other serial devices. Equipped with a DTR (Data Terminal Ready) pin, it supports automatic reset during programming, making it especially useful for flashing…
- Add to cart
-
- Modules, Other Modules
Mini 5V Traffic Light LED Display Module for Arduino Red Yellow Green 5mm LED
- 30.00 EGP
- Mini 5V Traffic Light LED Display Module with Red, Yellow, and Green 5mm LEDs. Perfect for Arduino, Raspberry Pi, and DIY projects to simulate real traffic signals. Ideal for education, robotics, and STEM learning.
- Add to cart
-
- Out of Stock
- Converters
XL4015 5A DC Buck Step Down Voltage Converter
- 90.00 EGP
- This module combines the high efficiency XMLSEMI XL4015 DC-DC buck converter IC with a TI LM358 Op-Amp for stable current regulation. This module offers much higher efficiency than LM2596 based modules which means less heat and more available power for your device.
- Read more
-
-
- Out of Stock
- Converters, Modules
Mini MP1584EN DC-DC Buck Adjustable Step Down Module 4.5V-28V Input 0.8V-20V Output
- 60.00 EGP
- The Mini MP1584 DC-DC 3A Adjustable Buck module is ultra small adjustable 0.8V to 20V output DC to DC Buck converter uses an MP1584EN high frequency switching regulator and integrated high voltage power MOSFET.
- Read more
-
-
- Other Modules
I2C Arduino Serial Module For LCD 16*2
- 40.00 EGP
- Simplify your LCD connections with this I2C serial interface module, designed specifically for standard 16x2 character LCD displays. This compact adapter converts the LCD's parallel interface into a simple I2C (I²C) 4-wire connection, drastically reducing wiring complexity and saving precious GPIO pins on your microcontroller.
- Add to cart
-
- Converters, Modules
Inverter Module DC 12V to AC 110V 175V 220V – 150W
- 430.00 EGP
- This 150W DC-AC Power Inverter Module efficiently converts 12V DC (from batteries, solar panels, or car power systems) into 110V, 175V, or 220V AC, making it ideal for powering small electronics, appliances, and tools in off-grid or mobile applications.
- Add to cart
-
- Converters
USB mini to TTL FTDI Board Module FT232RL Switchable 3.3V/5V
- 120.00 EGP
- The FT232RL USB to TTL Serial Converter Module is a high-performance USB-to-serial solution built around the reliable FTDI FT232RL chip. It allows seamless communication between your PC and microcontrollers or serial-based devices through USB. With a voltage selector switch, this module supports both 3.3V and 5V logic levels, making it compatible with a wide range of embedded systems, including Arduino…
- Add to cart
-
- Converters
MAX485 TTL To RS485 Converter Module
- 60.00 EGP
- 5V MAX485 TTL To RS485 Converter Module Board For Arduino
- Add to cart
-
- Other Modules
Joystick Module X-Y For Arduino
- 28.00 EGP
- Lots of robotic projects need a joystick. This module offers an affordable solution to that. The Joystick module is similar to analog joysticks found in gamepads. It is made by mounting two potentiometers at a 90 degrees angle. The potentiometers are connected to a short stick centered by springs.
- Add to cart
-
- Out of Stock
- Wireless
ESP8266 ESP-12F Wifi Transceiver Wireless Module
- 170.00 EGP
- The Latest ESP-12F ESP8266 Wi-Fi Module AP & Station Remote Serial Wireless IoT Board is an integrated chip designed for the needs of a new connected world. It can handle all the necessary overhead for communicating with your network, such as TCP/IP stack and communicating with your 802.11 networks. It is completely addressable over SPI and UART protocols allowing you…
- Read more
-
-
- Out of Stock
- Other Modules
Micro-USB Female Breakout Module
- 15.00 EGP
- A Female MicroUSB port with breakout board so you can solder on wires or header pins and integrate into any project.
- Read more
-
-
- Sale!
- Other Modules
GY-521 MPU6050 Triple 3-Axis Accelerometer Gyroscope I2C
- Original price was: 150.00 EGP.125.00 EGPCurrent price is: 125.00 EGP.
- The GY-521 module is a compact and powerful sensor board based on the MPU6050 chip, which combines a 3-axis accelerometer and a 3-axis gyroscope in a single package. This module is ideal for motion tracking, gesture detection, and stabilization in a wide range of applications including robotics, drones, gaming, and wearable tech.
- Add to cart
-
- Out of Stock
- Modules
AVR ISP 10Pin To ICSP 6Pin Converter V2
- 35.00 EGP
- AVR ISP 10Pin To ICSP 6Pin Converter V2 The standard 10PIN programmer can be used to interface to 6PIN Interface Converter. MCU development board can be used to download Interface Converter and also an Arduino development board can be used for the ISP interface converter.
- Read more
-
-
- Out of Stock
- Other Modules
MAX6675 Module for Thermocouple K Type
- 225.00 EGP
- This K Type Thermocouple can be used to measure temperatures up to 600 degree Celsius! Great for industrial projects, 3D Printers, DIY and hobby projects which require a high temperature to be measured.
- Read more
-
