-
- Out of Stock
- Environment Sensors
LDR Light Sensor Module 3 Pin
- 30.00 EGP
- 3 pin Photosensitive sensor module Photoresistor LDR
- Read more
-
-
- Other Modules
Led Matrix 8×8 With MAX7219 Module
- 140.00 EGP
- The MAX7219 Dot Led Matrix Module is a serial input common-cathode driver that interfaces micro-controllers to LED matrices
- Add to cart
-
- Other Modules
MAX6675 Module for Thermocouple K Type
- 240.00 EGP
- This K Type Thermocouple can be used to measure temperatures up to 600 degree Celsius! Great for industrial projects, 3D Printers, DIY and hobby projects which require a high temperature to be measured.
- Add to cart
-
- Out of Stock
- Other Modules
XY-LJ02 Timer Relay Delay Switch Module With LCD
- 137.50 EGP
- XY-LJ02 Timer Relay Delay Switch Module Delay Power Off and Trigger Delay Cycle Timing Circuit Switch with LCD Digital Display Compatible with Arduino
- Read more
-
-
- Out of Stock
- Converters
CP2102 Chip USB to TTL (Serial) Converter
- 150.00 EGP
- CP2102 is silab developed USB to serial chip, small size, may not require any peripheral components to reach into a simple USB-UART scheme, communication speed up to 1Mbps.
- Read more
-
-
- Out of Stock
- Converters
FTDI Module – USB to TTL (Switchable 3.3 or 5V) FT232RL
- 150.00 EGP
- The FTDI USB to TTL serial converter module is a UART (universal asynchronous receiver-transmitter) board used for TTL serial communication. It is a breakout board for the FTDI FT232R chip with a USB interface, can use 3.3 or 5 V DC and has Tx/Rx and other breakout points.
- Read more
-
-
- Out of Stock
- Converters
Hi Link AC-DC Module 220Vac to 3.3Vdc “HLK-PM03”
- 88.00 EGP
- Hi Link AC-DC Module 220Vac to 3.3Vdc "HLK-PM03" AC-DC 220V To 3.3Visolating Switch Power Supply Module/ Step-Down Module Output Overload And Short Circuit Protection Low Power Consumption, Environmental Protection, No-Load Loss <0.1W The Product Is Designed to Meet the Requirements of EMC And Safety Test It can use in IOT project, Smart home and so on.
- Read more
-
-
- Out of Stock
- Wireless
Xbee 2Mw 120M
- 330.00 EGP
- xbee XB24-Z7WIT-004 module from Digi. Series 2 improves on the power output and data protocol. Series 2 modules allow you to create complex mesh networks based on the Xbee ZB ZigBee mesh firmware. These modules allow a very reliable and simple communication between microcontrollers, computers, systems, really anything with a serial port! Point to point and multi-point networks are supported.…
- Read more
-
-
- Out of Stock
- Wireless
433MHZ TX/RXB6 MODULE
- 60.50 EGP
- 433MHZ TX/RXB6 MODULE
- Read more
-
-
- Out of Stock
- Motor Drivers
IBT-2 Motor Driver 43A
- 275.00 EGP
- IBT-2 43A H-Bridge Motor Driver Module the drive uses an H-bridge driver module that composed by Infineon power drive chip BTS7960, with overheating and overcurrent protection. motor driver H-bridge driver circuit, with strong drive and braking effect, use 74HC244 chip effectively isolate the microcontroller and the motor drive High Current up to 43A IBT-2 motor driver is a fully integrated…
- Read more
-
-
- Out of Stock
- Wireless
ESP8266 ESP-12F Wifi Transceiver Wireless Module
- 170.00 EGP
- The Latest ESP-12F ESP8266 Wi-Fi Module AP & Station Remote Serial Wireless IoT Board is an integrated chip designed for the needs of a new connected world. It can handle all the necessary overhead for communicating with your network, such as TCP/IP stack and communicating with your 802.11 networks. It is completely addressable over SPI and UART protocols allowing you…
- Read more
-
-
- Other Modules
Single Channel 5V DC Relay Module Solid State Low Level Trigger
- 70.00 EGP
- Single Channel 5V DC Relay Module Solid-State Low-Level Trigger, output with resistive fuse (240V 2A) It is a 1-channel solid state relay board, which can be controlled by a wide range of microcontrollers such as AVR, PIC, ARM, PLC, etc. With blue KF301terminal, more convenient for control line Standard interface can be connected with microcontrollers Solid State Relay Module Product…
- Add to cart
