GY-291 ADXL345 3-Axis is a small and efficient sensor with a high resolution (13-bit) that can measure an acceleration of up to ± 16g.
The module can be accessed via the I2C or SPI protocol and can be supplied with a voltage between 3V and 5V.60.50 EGP60.50 EGP
GY-61 ADXL335 Module is a small, thin, low-power, complete 3-axis accelerometer with signal conditioned voltage outputs.
The ADXL335 Module 3-axis Analog Output Accelerometer measures acceleration with a minimum full-scale range of ±3 g.
It can measure the static acceleration of gravity in tilt-sensing applications, as well as dynamic acceleration resulting from motion, shock, or vibration.
This breakout board comes with an onboard voltage regulator and works at both 3.3V & 5V (3-5V).
An accelerometer is an electro-mechanical device that will measure acceleration forces.
These forces may be static, like the constant force of gravity pulling at your feet, or they could be dynamic – caused by moving or vibrating the accelerometer.180.00 EGP180.00 EGP
TB6560 stepper motor driver can drive up to 3 stepper motors with 3.5 A peak current for each motor. It is also equipped with spindle relay output and can handle a spindle. It has micro-stepping capability up to 1/16 micro-step.
The driver is integrated with break output board (so you do not need one) and can be connected directly to the parallel port. In addition, it has a manual control port interface for manual control of your motors.
The 3-axis driver uses Toshiba TB6560AHQ chip and equipped with optical isolation with dc-dc power supply isolation for full protection. Finally, this driver is compatible with most parallel software MACH3, KCAM4 etc.!825.00 EGP825.00 EGP