Search Results for "avo"
-
2WD Smart Robot Car Chassis Aluminum
New Aluminum Smart Robot Car Chassis Kit for School Project Educational Robotics Engineering
400.00 EGP2WD Smart Robot Car Chassis Aluminum
400.00 EGP -
Apple Cable iPhone From Lightning to USB C – 1M
Connect your iPhone, iPad or iPod with Lightning connector to your MacBook with USB-C port or MacBook Pro with Thunderbolt 3 (USB-C) ports for syncing and charging
55.00 EGP -
Fluid Level Controller
The device connected to an electrical pump through an electrical cable ,is used for the auto-control and no-water protection of the water tower and water pool
319.00 EGPFluid Level Controller
319.00 EGP -
3M660-N Microstep Driver
3M660 is a constant torque microstepping driver, voltage range from 24-58VDC, it’s suitable for various 3-phase NEMA23 & NEMA34 hybrid stepper motorWith the build-in constant current chopping circuit similar to servo driver, the motor run stable without vibration and noise in low speed.
990.00 EGP3M660-N Microstep Driver
990.00 EGP -
FC-51 Infrared Obstacle Avoidance Proximity Sensor Module
FC-51 Infrared Obstacle Avoidance Proximity Sensor Module
30.00 EGP -
Ultrasonic Sensor Mounting Bracket Holder for HC-SR04
Need to mount your favorite ultrasonic sensor to your robot car ? This Laser cut mounting bracket is the easy solution
15.00 EGP -
Infrared Obstacle Avoidance Sensor Module
IR Infrared Obstacle Avoidance Sensor Module has a pair of infrared transmitting and receiving tubes.
When the transmitted light waves are reflected back, the reflected IR waves will be received by the receiver tube.
The onboard comparator circuitry does the processing and the green indicator LED comes to life.
The module features a 3 wire interface with Vcc, GND and an OUTPUT pin on its tail.
It works fine with 3v3 to 5V levels.
Upon hindrance/reflectance, the output pin gives out a digital signal (a low level signal).
The onboard preset helps to fine tune the range of operation, effective distance range is 2cm to 80cm.
75.00 EGP -
IR Infrared Receiver Photo-diode Receiver 5mm
IR Photo diode is used to detect the light rays reflected from an IR LED. Photo diode is a reverse biased PN junction diode. When photo diode is exposed to light, electrical resistance across the diode decreases there by increasing the reverse current. If the photodiode is not exposed to light, resistance across the will be high .hence reverse current will be extremely small. This current is known as dark current. When light falls on photo diode, electrons acquire sufficient energy to break the covalent bond. Thus free electrons and holes are created. These free electrons will increase the reverse current. Basic circuit of an IR sensor using IR led and IR photo diode is shown below. IR transmitter LED will be emitting IR rays continuously since it’s connected in forward biased state. When an obstacle is present, IR rays from LED gets reflected back and IR receiver will capture these rays. Now IR receiver will conduct, an active low output will be produced.
5.00 EGP -
-
-
High Quality AVO Probe
Multimeter/AVO Probes High Quality
45.00 EGPHigh Quality AVO Probe
45.00 EGP