-
- Other Modules
Joystick Module X-Y For Arduino
- 40.00 EGP
- Lots of robotic projects need a joystick. This module offers an affordable solution to that. The Joystick module is similar to analog joysticks found in gamepads. It is made by mounting two potentiometers at a 90 degrees angle. The potentiometers are connected to a short stick centered by springs.
- Add to cart
-
- Other Modules
Relay Module 1 Channel 5V
- 40.00 EGP
- The Single Channel Relay Module is a convenient board that can be used to control high voltage, high current loads such as motor, solenoid valves, lamps, and AC load. It is designed to interface with microcontrollers such as Arduino, PIC and etc. The relays terminal (COM, NO, and NC) is being brought out with a screw terminal. It also comes…
- Add to cart
-
- Other Modules
High-power MOSFET Trigger Switch Drive Module
- 40.00 EGP
- High-power MOSFET Trigger Switch Drive Module
- Add to cart
-
- Other Modules
Micro SD Card Module
- 40.00 EGP
- Micro SD card mini TF card reader module SPI interfaces with level converter chip
- Add to cart
-
- Modules, Other Modules
Mini 5V Traffic Light LED Display Module for Arduino Red Yellow Green 5mm LED
- 40.00 EGP
- Mini 5V Traffic Light LED Display Module for Arduino Red Yellow Green 5mm LED RGB -Traffic Light for Traffic Light System Model
- Add to cart
-
- Out of Stock
- Other Modules
12V Battery Level LED Indicator
- 45.00 EGP
- XD-82B 12V Battery Level Indicator Module 4 Paragraph 4 onboard Battery Indicator LED Lights. Monitor the level of your 12v battery and know when it’s running low with this small LED battery level indicator.
- Read more
-
-
- Out of Stock
- Other Modules
12V Delay Timer Switch Adjustable
- 45.00 EGP
- This 12V Delay Timer Switch Adjustable 0-10sec is one kind of popular switch module. You can use it control any devices on or off. This is a DC12V controlled 1 channel timer relay module. It has a NE555 timer chip on the board. You can adjust delay time(0-10s) by rotating the potentiometer. When this relay get powered it will delay…
- Read more
-
-
- Other Modules
I2C Arduino Serial Module For LCD 16*2
- 55.00 EGP
- This is I2C Arduino Serial Module For LCD board that can be connected to a standard HD44780 compatible 16×2 , 20×4 or 20×2 Character Display Module that supports 4 bit mode.This board has a PCF8574 I2C chip that converts I2C serial data to parallell data for the LCD display.
- Add to cart
-
- Out of Stock
- Other Modules
Relay 1 channel 30A 240VAC
- 55.00 EGP
- 30A relay module, normally open interface with maximum load: AC 240V/30A, DC 30V/30A
- Read more
-
-
- Out of Stock
- Other Modules
SD Card Module, SPI Interface
- 55.00 EGP
- This is a wonderful little Arduino to SD card interface module.Through programming, you can read and write to the SD card using your arduino.If you are feeling adventurous, this is truly an interesting board to work with and learn from.It is easily interfaced as a peripheral to your arduino sensor shield module.
- Read more
-
-
- Out of Stock
- Other Modules
Lipo Battery Voltage Tester / Low Voltage Buzzer Alarm
- 55.00 EGP
- LIPO Battery Voltage Tester and low voltage buzzer alarm combo is easy to use. Li-Po Battery Voltage Buzzer Indicator: directly plug it into your operating battery, it will monitor the conditions of your battery all the time, so your batteries shall remain within safe operating voltage range at all times.
- Read more
-
-
- Out of Stock
- Other Modules
GY-291 ADXL345 3-Axis Accelerometer
- 60.50 EGP
- GY-291 ADXL345 3-Axis is a small and efficient sensor with a high resolution (13-bit) that can measure an acceleration of up to ± 16g. The module can be accessed via the I2C or SPI protocol and can be supplied with a voltage between 3V and 5V.
- Read more
-
