-
- Out of Stock
- Other Modules
CH376S U Disk Read Write Module For USB Control Transfer
- 110.00 EGP
- CH376 is common a USB bus interface chip, with 8 bit data bus and reading, writing and chip select lines and interrupt output, can easily attached to the system bus of the single chip microcomputer /DSP/MCU/MPU controller.
- Read more
-
-
- Other Modules
Relay Module 1 Channel 5V
- 40.00 EGP
- The Single Channel Relay Module is a convenient board that can be used to control high voltage, high current loads such as motor, solenoid valves, lamps, and AC load. It is designed to interface with microcontrollers such as Arduino, PIC and etc. The relays terminal (COM, NO, and NC) is being brought out with a screw terminal. It also comes…
- Add to cart
-
- Other Modules
I2C Arduino Serial Module For LCD 16*2
- 55.00 EGP
- This is I2C Arduino Serial Module For LCD board that can be connected to a standard HD44780 compatible 16×2 , 20×4 or 20×2 Character Display Module that supports 4 bit mode.This board has a PCF8574 I2C chip that converts I2C serial data to parallell data for the LCD display.
- Add to cart
-
- Other Modules
Joystick Module X-Y For Arduino
- 40.00 EGP
- Lots of robotic projects need a joystick. This module offers an affordable solution to that. The Joystick module is similar to analog joysticks found in gamepads. It is made by mounting two potentiometers at a 90 degrees angle. The potentiometers are connected to a short stick centered by springs.
- Add to cart
-
- Modules, Other Modules
Mini 5V Traffic Light LED Display Module for Arduino Red Yellow Green 5mm LED
- 40.00 EGP
- Mini 5V Traffic Light LED Display Module for Arduino Red Yellow Green 5mm LED RGB -Traffic Light for Traffic Light System Model
- Add to cart
-
- Other Modules
Micro-USB Female Breakout Module
- 15.00 EGP
- A Female MicroUSB port with breakout board so you can solder on wires or header pins and integrate into any project.
- Add to cart
-
- Other Modules
GY-521 MPU6050 Triple 3-Axis Accelerometer Gyroscope I2C
- 155.00 EGP
- The MPU6050 contains both a 3-Axis Gyroscope and a 3-Axis accelerometer allowing measurements of both independently, but all based around the same axes, thus eliminating the problems of cross-axis errors when using separate devices.
- Add to cart
-
- Other Modules
MAX6675 Module for Thermocouple K Type
- 240.00 EGP
- This K Type Thermocouple can be used to measure temperatures up to 600 degree Celsius! Great for industrial projects, 3D Printers, DIY and hobby projects which require a high temperature to be measured.
- Add to cart
-
- Other Modules
Relay Module 4 Channel – 5V DC
- 140.00 EGP
- Relay Module 5Vdc – 4 Relay For Arduino & MCU H/L Trigger
- Add to cart
-
- Components, Other Modules, Relays
Relay Module 2 Channel 12V (high/low) level trigger
- 75.00 EGP
- This is a HIGH/LOW Level 12V 2-channel relay interface board, and each channel needs a 20mA driver current. It can be used to control various appliances and equipment with large current. It is equipped with high-current relays that work under AC 250V 10A or DC 30V 10A. It has a standard interface that can be controlled directly by microcontroller
- Add to cart
-
- Out of Stock
- Other Modules
12V Delay Timer Switch Adjustable
- 45.00 EGP
- This 12V Delay Timer Switch Adjustable 0-10sec is one kind of popular switch module. You can use it control any devices on or off. This is a DC12V controlled 1 channel timer relay module. It has a NE555 timer chip on the board. You can adjust delay time(0-10s) by rotating the potentiometer. When this relay get powered it will delay…
- Read more
-
