Search Results for "power supply"
-
Relay Module 8 Channel 5V
This is a 5V 8-Channels Relay module, It can be controlled directly by a wide range of microcontrollers such as Arduino, AVR, PIC, ARM and MSP430.
8 relays are included in this module, with “NC” ports means “Normally connected to COM” and “NO” ports means “Normally open to COM”. This module also equipped with 8 LEDS to show the status of relays
195.00 EGPRelay Module 8 Channel 5V
195.00 EGP -
Ublox NEO-6m GPS tested Module
Ublox makes good gps. The Ublox NEO-6M gps engine on this board is a quite good one, with high precision binary output. It has also high sensitivity for indoor applications. The gps module have a battery for power backup and EEprom for storing configuration settings.
The antenna is connected to module through ufl cable which allow for flexibility in mounting the gps such that the antenna will always see the sky for best performance. This make it powerful to use with cars and other mobile applications.
The Ublox gps module has serial TTL output, it has four pins:TX, RX, VCC and GND. You can download the u-center software for configuring the gps and changing the settings and much more. It is really good software (see link below).
600.00 EGPUblox NEO-6m GPS tested Module
600.00 EGP -
GY-45 MMA845 3-Axis Accelerometer Module
The MMA8452 is a smart low-power, three-axis accelerometer with 12 bits of resolution.
This accelerometer is packed with embedded functions with flexible user programmable options, configurable to two interrupt pins.
The MMA8452 has user selectable full scales of ±2g/±4g/±8g. The device can be configured to generate inertial wake-up interrupt signals allowing the MMA8452 to monitor events and remain in a low power mode during periods of inactivity.
This board breaks out the ground, power, I2C and two external interrupt pins.
100.00 EGPGY-45 MMA845 3-Axis Accelerometer Module
100.00 EGP -
Bluetooth V4.0
Bluetooth 4.0 Module HM-10 Transparent Serial Port Module with Logic Level Conver Sion/Anti.
210.00 EGPBluetooth V4.0
210.00 EGP -
LV25-P LEM Voltage Transducer
A PCB mounting voltage transducer based on the Hall effect. The unit provides galvanic isolation between primary and secondary circuits. To enable a voltage to be measured a current proportional to the measured voltage must be collected through an external resistor, selected by the user, in series with the primary circuit of the unit.
1,188.00 EGPLV25-P LEM Voltage Transducer
1,188.00 EGP