TFT LCD Display Module SPI Interface 1.8 Inch 128*160
245.00 EGP
1.8 inch SPI TFT LCD Display Module for ST7735 128×160 51/AVR/STM32/ARM 8/16 bit
Out of stock
Description
1.8 TFT SPI 128*160 (Color LCD)
- TFT LCD module has always been one of the hot products in DIY industry and LCD is basically the necessary products during all projects, at the same time, serial port modules are also the popular ones, because it takes few IO and the usage is simple.
- This section of the 1.8-inch TFT LCD serial SPI integrated features of compact, SPI interface.
- 1.8-inch color screen,support 65K color display,display rich colors
- 128X160 resolution, clear display
- Using the SPI serial bus, it only takes a few IOs to illuminate the display
- With SD card slot for convenient function expansion
- Provide underlying libraries and rich sample programs for Arduino, C51, and STM32 platforms
- Military-grade process standards, long-term stable work
- Provide underlying driver technical support
Feature
- It is a 1.8 “”SPI TFT LCD Screen Module, 9pins interface. Not just a LCD break but include SD card (2GB),
- The LCD drive ic is ST7735S.
- It’s a 128 X 160 (resolution).
- The LCD has a wide viewing angle, the contrast is also very suitable.
- The display interface is serial, it just needs 5 wires (CS, RS, SCL, SDA, RST) for controlling.
- SDcard use hardware SPI interface (CS / MOSI / MISO / SCK), Not solder pins.
Parameters
Number | Pin Label | Description |
1 | VCC | LCD Power positive (3.3V~5V) |
2 | GND | LCD Power ground |
3 | GND | LCD Power ground |
4 | NC | Not defined, reserved |
5 | NC | Not defined, reserved |
6 | NC | Not defined, reserved |
7 | CLK | LCD SPI bus clock signal |
8 | SDA | LCD SPI bus write data signal |
9 | RS | LCD register / data selection signal,high level: register, low level: data |
10 | RST | LCD reset signal, low level reset |
11 | CS | LCD chip select signal, low level enable |
- LED 3.3V IO and Power Supply pin
- LED UTFT Support
- SCL Serial clock input
- SDA/SDI Serial data input
- DC:Data/Command selection
- RST:Reset Low level active
- CS:Chip Selection,Low level active
- GND:Ground
- VDD33:3.3V Power Supply pin
Guide to 1.8 TFT Display with Arduino
Connect to Arduino:
Package Included:
- 1 X 1.8 TFT SPI 128*160 (Color LCD )
“
Additional information
Dimensions | 6.2 × 3.8 cm |
---|